Alex Snodgrass on Bandsaws – 360w360 E.219

The 360 WoodWorking guys talk with Alex Snodgrass on bandsaws.In this episode of 360 with 360WoodWorking the 360 guys talk with Alex Snodgrass on bandsaws.

Join the guys twice each week for six lively minutes of discussion on everything from tools to techniques to wood selection (and more). Chuck & Glen, and sometimes a surprise guest, all have their own opinions. Sometimes they agree and sometimes they don’t, but the conversation is always information packed and lots of fun.

If you have topics you’d like to hear covered in future episodes, click here to send an email to the guys.

Alex Snodgrass on Bandsaws

 

Alex Snodgrass has been around bandsaws a long time…a long, long time. The upside is, he’s learned a thing or two about how to make them work for you, instead of against you. The golden nuggets of his experience pop up throughout this episode where the guys talk with Alex Snodgrass on bandsaws.

If you haven’t joined 360WoodWorking already, click here to get even more great woodworking information. You can even give the gift of woodworking knowledge to someone you know, by clicking here.

Posted on

One thought on “Alex Snodgrass on Bandsaws – 360w360 E.219

  1. Gullet on the crown works great for me. But I have a question and a comment. First the question, since the back edge of the blade (assuming it is wide enough to have a back edge hanging off the other side of the crown — this prompts second question) can waggle a bit, does this have a noticeable effect on kerf width? I don’t have ultra-thin blades or minimal set blades on my bandsaw so I doubt I’d see or notice anything.

    As a comment, I’ve discovered that the eccentric guides on my bandsaw have “spacers” that are a little too thick and make it difficult to pull the side guide bearings back far enough when the gullet is on the crown. I can do it but it took a little creative filing. I’d have the same problem mounting a 3/16″ blade in the “normal” fashion too. Not a show-stopper, just something to be prepared for the first time.

Leave a Reply

Your email address will not be published. Required fields are marked *